Description
This is an Ametek replacement vacuum motor for your NuTone VX475 and NuTone VX475C, 120 volt.
It has more than a 1/2″ taper at the bottom (see additional picture).
It is suggested that you replace the motor gasket, see our part #MTR512.
Uses motor brushes part MTR523.
CARBON BRUSHES ABOVE WILL NOT FIT THE ORIGINAL NUTONE MOTOR THAT COMES IN THE VX475. THESE BRUSHES WILL ONLY FIT THE AMETEK VERSION OF THE ORIGINAL MOTOR.
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
