Description
New Lamb Ametek 119631-00 conical design motor is 2-stage, 5.7 inch, 120 volt.
It has more than a 1/2″ taper at the bottom (see additional picture).
It is suggested that you replace the motor gasket, see our part #MTR512.
Uses motor brushes part MTR523.
Motor Specs
- Motor Type: Bypass
- Discharge: Tangential
- Bearings: Double Ball Bearing
- Sealed Vacuum: 128 inches
- Maximum Air Watts: 515
- Maximum Air Flow: 114.5 CFM
- Maximum Amps: 14.4
- Motor Speed: 28,743 RPM
*We reserve the right to substitute a motor with a motor of equal or better performance. The substituted motor will be a manufacturer’s direct recommended replacement motor that is in factory new condition. The reason for substitution may be due to a discontinued motor or lack of production stock. We make every effort to provide you with the motor that you originally ordered. If you have any questions or concerns please contact us prior to placing your order.
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
