Description
New Lamb Ametek 119562-00 motor is 1-stage, 5.7 inch, 120 volt.
It has more than a 1/2″ taper at the bottom (see additional picture).
It is suggested that you replace the motor gasket, see our part #MTR512.
Uses motor brushes part #MTR501.
Motor Specs:
- Discharge: Thru Flow
- Bearings: Double Ball Bearings
- Sealed Vacuum: 95.8 inches
- Maximum Air Watts: 443
- Maximum Air Flow: 139.3 CFM
- Max Amps: 11.3 AMPS
- Motor Speed: 35000 RPM
SPECIAL ORDER
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
