Description
New Lamb Ametek 116472-18 motor is 2-stage, 5.7 inch, 120 volt.
This motor has an extra PTFE seal to prevent water from finding its way into the bearing while the motor is not moving. The improved bearing design increased the life of the motors on the abusive “suds” test where the fan systems are subjected to a caustic soapy mist.
DON’T RISK PREMATURE FAILURE FOR YOUR NEW MOTOR!
We HIGHLY recommend the maximum protection of your motor by using our exclusive Filtered Motor Gasket, part #MTR1500. Our Filtered Motor Gasket is the only one of its kind and only available from Central Vacuum Factory! It is specially designed by our engineers to provide your motor with years of trouble free service by filtering out dust and dirt BEFORE they reach your motor and damaging it! The filtered motor gasket fits flush and is as easy to apply as a regular gasket and will not add any height to your motor during mounting!
For our standard motor gasket, see our part #MTR512.
Protect your motors from dust and dirt by using a motor filter. This prolongs the life of your motor and is a must for all motors. See our standard motor filter part #MTR553.
Uses motor brushes part MTR501.
For our extended life motor brushes see our part #MTR555. These extended life motor brushes will last approximately 900-1000 operational hours depending on application and weather conditions. As compared to the standard motor brushes which will have approximately 600-700 operational hours.
Motor Specs
- Motor Type: Bypass
- Discharge: Tangential
- Bearings: Double Ball Bearing
- Sealed Vacuum: 106.7 inches
- Maximum Air Watts: 404
- Maximum Air Flow: 112 CFM
- Maximum Amps: 11.7
- Motor Speed: 20,350 RPM
SPECIAL ORDER
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
