Description
This is the Genuine CycloVac Newer Generation Upper Vacuum Motor for the DL200, DL2010, GX2010, and DL2015, 120 volt. This motor is the genuine CycloVac part #TMCY2001T.
These vacuums use 2 motors. You may want to replace both motors at the same time as most vacuum motors are designed to operate up to 600 hours before they need replacing. If one motor has failed the other will most likely fail shortly there after. It is much easier to replace them both now and save time, money and effort.
If you need replacement motor brushes for the TMCY2001T vacuum motor, see our part #MTR531.
SPECIAL NOTE! This replaces the top motor only. If you need the bottom motor for the newer generation, see our part #MTR2196.
SPECIAL NOTE! This motor is for the newer style of CycloVac central vacuum models DL200, DL2010, GX2010, and DL2015 that have an exhaust tube on the motor. If you need the older generation motors (without exhaust tube/horn) see our part #MTR2239.
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
