Description
This is an Ametek Vacuum Motor for your Centralux, Electrolux models E130A, E130F, E130G, E130K and CV3291 and may fit some Centralux and Electrolux model from the 1950’s, 120 volt.
Please Note: The bottom of this motor is not flat, it tapers down over 1/2 inch. If your motor does not taper and is completely flat on the bottom you will need to order a different motor. You will need to order part MTR1084.
Replaces 6600-001 including HL10 P-9 ECD. Also, you will clip the wires from the old motor to splice into the new motor wires. You may need wire nuts and possibly washers to make up 1/8″ difference on bolt threads when tightening.
DON’T RISK PREMATURE FAILURE FOR YOUR NEW MOTOR!
We HIGHLY recommend the maximum protection of your motor by using our exclusive Filtered Motor Gasket, part #MTR1500. Our Filtered Motor Gasket is the only one of its kind and only available from Central Vacuum Factory! It is specially designed by our engineers to provide your motor with years of trouble free service by filtering out dust and dirt BEFORE they reach your motor and damaging it! The filtered motor gasket fits flush and is as easy to apply as a regular gasket and will not add any height to your motor during mounting!
For our standard motor gasket, see our part #MTR512.
Uses motor brushes part MTR523.
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
